series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 1 of 6 north america only f eatures: ? ultra wide 4:1 input range ? remote on/off control ? efficiency up to 91% ? input/output isolation 1600vdc ? soft start ? operating temperature - 40 o c to + 7 5 o c ? continuous short circuit protection ? rohs compliant m odels single output model input voltage (v) output voltage (v) output current max ( a) maximum capacitive load ( uf ) efficiency (%) am30ew - 2403sz 9 - 36 3.3 7.5 20000 86 am30ew - 2405sz 9 - 36 5 6 14000 88 am30ew - 2405.1sz 9 - 36 5.1 6 14000 88 am30ew - 2412sz 9 - 36 12 2.5 2000 89 am30ew - 2415sz 9 - 36 15 2 2000 89 am30ew - 4803sz 18 - 75 3.3 7.5 20000 86 am30ew - 4805sz 18 - 75 5 6 14000 88 am30ew - 4805.1sz 18 - 75 5.1 6 14000 88 am30ew - 4812sz 18 - 75 12 2.5 2000 90 am30ew - 4815sz 18 - 75 15 2 2000 91 models dual output model input voltage (v) output volta ge (v) output current max (a) maximum capacitive load ( uf ) efficiency (%) am30ew - 2405dz 9 - 36 5 3 3000 88 am30ew - 2412dz 9 - 36 12 1.25 1300 87 am30ew - 2415dz 9 - 36 15 1 1300 87 am30ew - 4805dz 18 - 75 5 3 3000 88 am30ew - 4812dz 18 - 75 12 1.25 13 00 88 am30ew - 4815dz 18 - 75 15 1 1300 88 models triple output model input voltage (v) output voltage (v) output auxiliary voltage (v) output current max (a) maximum capacitive load ( uf ) efficiency (%) am30ew - 240312tz 9 - 36 3.3 12 5 / 0.42 15000 / 220 88 am30ew - 240315tz 9 - 36 3.3 15 5 / 0.33 15000 / 220 88 am30ew - 240512tz 9 - 36 5 12 4 / 0.42 8000 / 220 90 am30ew - 240515tz 9 - 36 5 15 4 / 0.33 8000 / 220 90 am30ew - 480312tz 18 - 75 3.3 12 5 / 0.42 15000 / 220 88 am30ew - 480315tz 18 - 75 3.3 1 5 5 / 0.33 15000 / 220 88 am30ew - 480512tz 18 - 75 5 12 4 / 0.42 8000 / 220 90 am30ew - 480515tz 18 - 75 5 15 4 / 0.33 8000 / 220 90 note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specified.
series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 2 of 6 north america only input specifications parameters nominal typical maximum units voltage range 24 9 -36 vdc 48 36 - 75 filter (pi) network start up time 30 ms absolute maximum rating 24 - 0.7 ~ 50 vdc 48 - 0.7 ~ 100 peak input voltage time 100 ms on/off c ontrol on: 3 ~12vdc or open circuit off: 0 ~ 1.2vdc or short circuit between pin 2 and pin 3 no load input cur rent vin 9~36 100 ma vin 36~75 50 under voltage lockout 24v on/off 8.8 / 7.9 vdc 48v on/off 17.8 / 16 input r eflected c urrent 20 map -p isolation specifications parameters conditions typical rated units tested i/o voltage 3 sec 1600 vdc c ase/input tested voltage 3 sec 1600 vdc resistance 1000 mohm capacitance 1500 pf output specifications parameters conditions typical maximum units voltage accuracy (single and dual) 1 % voltage accuracy (triple) main / auxiliary 1 / 5 cr oss regulation (dual output models) 25% load on one output - 100% load on second load 5 % cross regulation ( triple ) main 100%, 25% load on aux1 and 100% on aux2 5 over voltage protection zener diode clamp over current protection 120 % short circ uit protection continuous short circuit restart auto - recovery thermal shutdown case temp 115 o c line voltage regulation (single) hl - ll 0.2 % line voltage regulation (dual) hl - ll 0.2 % line voltage regulation (triple) hl - ll main / auxiliary 1 / 5 % load voltage regulation (single) 0 - 100% load 0.5 % load voltage regulation (dual) balanced load 1 % load voltage regulation (triple) 10~100% main / auxiliary 1 / 5 % temperature coefficient 0.02 %/ o c ripple & noise (single and dual) 20m hz b andwidth , 3.3v/5v/5.1v/5v 100 mv p -p 20mhz b andwidth , 12v/15v/12v/15v 150 ripple & noise (triple) 20mhz b andwidth main / auxiliary 50 / 75 mv p - p voltage adjustment range (single) 10 % minimum load current 10 % of max general specifi cations parameters conditions typical maximum units switching frequency 100 % load 330 khz operating temperature derating above 50 - 40 to +75 o c storage temperature - 40 to +125 o c maximum case temperature 10 5 o c
series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 3 of 6 north america only general specifications (continued) parameters conditions typical maximum units derating 2 %/ o c cooling free air convection humidity 95 % rh case material nickel coated copper weight 30 g dimensions (l x w x h) 2.00 x 1.00 x 0.4 inches 50.80 x 25.40 x 10.17 mm mtbf single & dual: >450000 hrs (mil - hdbk - 217f, ground benign, t=+25 o c) triple: >320000 hrs (mil - hdbk - 217f, ground benign, t=+25 o c) maximum soldering temperature 1.5mm from case for 10 sec 260 o c transient recovery time 250 u s transient recovery deviation 3 % safety specifications parameters agency approval ce standards en55022 class a, en55024 iec61000 - 4 - 2, perf. criteria b iec61000 - 4 - 3, perf. criteria a iec61000 - 4 - 4, perf. criteria b (external 22 0uf/100v cap required) iec61000 - 4 - 5, perf. criter ia b (external 22 0uf/100v cap required) iec61000 - 4 - 6, perf. criteria a iec61000 - 4 - 8, perf. criteria a pin out specifications pin single dual triple 1 + v input + v input + v input 2 - v input - v input - v input 3 on/off control on/off control on /off control 4 + v output + v output + vaux output 5 - v output common - vaux output 6 trim - v output common 7 no pin no pin + v output dimensions 1 2 3 2.54 (0.10) 5.08 (0.20) 10.16 (0.40) 50.80 (2.00) 25.40 (1.00) bottom view 2.54 (0.10) 2.54 (0.10) 10.16 (0.40) 10.16 (0.40) 10.16 (0.40) 5.08 (0.20) single and dual output models 5.08 (0.20) 4 5 6 notes: all dimensions are typical in millimeters (inches ). pin pitch tolerance 0.35 (0.014) case tolerance 0.50 (0.02) diameter 1.00 (0.04)
series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 4 of 6 north america only notes: all dimensions are typical in millimeters (inches ). pin pitch tolerance 0.35 (0.014) case tolerance 0.50 (0.02) 1 2 3 2.54 (0.10) 5.08 (0.20) 50.80 (2.00) 25.40 (1.00) bottom view 2.54 (0.10) 2.54 (0.10) 10.16 (0.40) 5.08 (0.20) triple output models 4 5.08 (0.20) 7.64 (0.30) 7.64 (0.30) 10.16 (0.40) 5.08 (0.20) 5 6 7 trimming derating on /off control dc/ dc converter +v input -v input on/off control 6 7 4 5 positive logic turns on the module during high logic and off during low logic. m odule can be controlled by an external switch between the on/off ctrl terminal and C vin put terminal. the switch can be either open c ollector or open drain. - 40 - 20 0 20 40 60 80 100 100 80 60 40 20 0 safe operating area o u t p u t p o w e r ( % ) 75 ambient temperature o c free air convection 50 o c
series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 5 of 6 north america only recommended circuits c1 l c2 100uf, 100v 12uh 1206, 470pf, 2kv conducted / radiated emissions dual output l c1 c2 dc/dc converter + v input - v input + v output common load load - v output conducted / radiated emissions single output l c1 c2 dc/dc converter + v input - v input + v output load - v output conducted / radiated emissions triple output l c1 c2 dc/dc converter + v input - v input + v output common + vaux output - vaux output load load load
series am 30ew -z 30 watt | dc - dc converter www.aimtec.com tel: + 1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 051e r11.j 6 of 6 north america only surge/eft c1 220uf, 100v su ge / dc/dc converter +v input -v input c1 6 7 4 5 note: 1. datasheets are updated as needed and a s such, specifications are subject to change without notice. once printed or downloaded, datasheets are no longer controlled by aimtec; refer to www.aimtec.com for the most current product specifications. 2. product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. mechanical drawings and specifications are for reference only. 4. all specifications are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated ou tput load unless otherwise specifie d. 5. aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered pro prietary and may not be available for release. 6. this product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control s ystems or other such applications which necessitate specific safety and reg ulatory standards other the ones listed in this datasheet. 7. warranty is in accordance with aimtecs standard terms of sale available at www.aimtec.com.
|
